Looking to find which flat-head replacement screws I should buy for my Teese wah so I can mount it flush w/ velcro to the pedalboard. I know they certainly have to be shorter than the originals because the originals don't sink in deep enough without the feet to keep the back plate on

It's a Dunlop case, so... any suggestions?

Thanks,
Ben

Ive seen them on the net, instead of replacing the screws, somebody sells a bottom plate for the Dunlop cased wahs that is thicker and will allow flush mounting. I'm not sure where I saw it. I just mounted velcro to the bottom of my wah and used the original screws with no problem. they do stick out but the pedal will mount to a board and it's pretty solid.

I went to the hardware store today and found the screws I needed: 6-32, 3/8" flat-headed screws. Worked nicely, and much more flush than the originals. Although, 1 damn screw-head broke off, but otherwise everything is sealed tightly and the pedal is velcroed tightly and nicely to the board.

Thanks for the reply though, and I think I'll keep an eye out for that replacement plate anyway!

-Ben