I've noticed that on my ts9 the signal will intermittently cut out on me. When I pull up on the tone knob, the signal comes back in. Does this mean I have to replace my tone pot? If so, does anyone have any idea where I could find a replacement?

Thanks

pop it open and look at it, wires loose?

No, all of the joints look solid.

Sorry for my english, Danish you see....
and I don't know if this is your problem, but I have had troubles with the TS pot's getting loose every now and then, and when you turn the knob, the pot turnes inside and one of the solder eyes hits the chassis (ground) and make a short...= no sound.... this drove me nuts fro quite a while, couldn't figure outy what was wrong...resoldered almost the entire pcb board, before I finally found the problem....damn...

KingBee

Don't worry, your English is very good!

I actually found the same problem was happening with my pedal. At least, I thought that was what was happening, so I think you've just comfirmed what I was suspecting. Thanks for the reply!

Sounds like the board is shorting out against something.